Tabla de contenido
Idiomas disponibles
Idiomas disponibles
HAND WRING CLOTHS TO REMOVE EXCESS LIQUID. CLOTHS SHOULD BE DAMP, BUT NOT DRIPPING. THE
CDR IS NOT DESIGNED FOR SPRAY DOWN OR POURING OF LIQUIDS ONTO MECHANISM. PERMANENT
1.
Disconnect/unplug CDR from power
2.
Remove all scrapers (SEE previous PAGE)
3.
Clean the rolls, infeed/output trays and scrapers by:
a.
Dampen a clean cloth in soapy water, wash all plastic surfaces
b.
Using a different clean cloth, dampen with clean/clear water and rinse all surfaces
c.
Dampen a clean cloth with sanitizer, sanitize all surfaces
d.
Allow all food contact surfaces to air dry
e.
APPLY A THIN FILM OF COOKING OIL WITH A CLOTH
4.
Brush or wipe the sides of the machine and the trays
5.
Clean all the scrapers and verify they are not worn
6.
All beveled edges should be smooth and not nicked.
7.
Install the scrapers in the opposite order of removal.
8.
Close the safety cover and secure it with the four thumb screws
9.
Reconnect/plug into power
10.
Press the green start switch when the machine is ready to use
♦
Equipment food-contact surfaces should be clean to sight and touch.
Fondant Discharge Tray is only
included with the CDR-500F
*NOTE: Fondant tray can be ordered as an accessory and added in the field to any CDR-500
NEVER USE OIL OR GREASE ON ANY OF THE MECHANICAL PARTS OF THE MACHINE.
ALL MECHANICAL PARTS ARE PERMANENT SELF LUBRICATED.
L020-080
WARNING
MACHINE DAMAGE MAY RESULT.
CLEANING
Quick Tips
!! CAUTION !!
THIS MACHINE IS MAINTENANCE FREE.
PAGE 4 OF 4
The Scraper pin under the
scraper #2 is there for the
discharge tray.
REV B – JULY 2019
Tabla de contenido
