Tabla de contenido
Ventilation Systems
4. DO NOT OPERATE MACHINE while hanging on this bolt. Level machine and secure machine using
3/8" x 2" Lag bolts (supplied) in the (6) mounting locations. (Figure 2)
(4) Inside
chassis
mounting
locations
5. When connecting chains, the load nut should be near the "Closed" position to allow enough
chain/cable for manual winch connection.
6. Run chain ends through side of machine around sprocket down to the load block. Route chains
around sprockets as shown in below figures that best suits the application.
Hog Slat Inc. Newton Grove, NC USA May 2019 REV A10
(2) External
Mounting
Locations
Figure 2
Vertical mount and outdoor installations,
DO NOT REMOVE PLUGS IN TOP OF
MACHINE
If mounting does not allow the use
of these locations, install 3/8" to
1/2" diameter bolts with nuts in the
holes to secure internal thrust plate
to machine cabinet. Failure to
secure the thrust plate could result
in plate damage during heavy-load
conditions.
8
Tabla de contenido
