Tabla de contenido
Ventilation Systems
INSTALLATION / OPERATION
1. The HS583E Curtain/Vent machine is equipped with a key hole slot for easy installation as well as
(6) locations to secure unit to a wall.
2. Install (1) 3/8" X 3" Lag bolt (supplied) in the wall of the building in the desired location leaving
bolt out approximately ¼". Lag bolt location to be center line of the machine and installed 6 1/4"
below the height of the top of the machine. Allow a minimum of 1" clearance above machine
from any structure in order to provide adequate clearance for hanging machine on keyhole lag
bolt.
3. Hang machine on bolt aligning keyhole slot located near top of the machine. (Figure 1)
Hog Slat Inc. Newton Grove, NC USA May 2019 REV A10
Figure 1
Keyhole
mounting
location
MODEL LENGTH
24"
30 3/8"
36"
42 3/8"
48"
54 3/8"
"A"
7
Tabla de contenido
