Tabla de contenido
Idiomas disponibles
Idiomas disponibles
• Extensive use could lead to the product's excessive heating and
shorter life. Should this occur, discontinue use and allow the unit
to cool before operating.
• NEVER use this product directly on swollen or inflamed areas or
skin eruptions.
• This product is a non-professional appliance designed to provide
soothing massage to worn muscles. DO NOT use this product as a
substitute for medical attention.
• DO NOT use this product before bed. The massage has a
stimulating effect and can delay sleep.
• NEVER use this product while in bed.
• This product should NEVER be used by any individual suffering
from any physical ailment that would limit the user's capacity to
operate the controls.
• This unit should not be used by children or invalids without adult
supervision.
• This product should never be used by any individual suffering from
any ailment that would limit or altogether inhibit the user's capacity
to feel or have any sensation in the body part that the product is
being used on.
Instructions for Use
To reduce the risk of electric shock, this appliance has a polarized
plug (one blade is wider than the other). This plug will fit in a
polarized outlet only one way. If the plug does not fit fully in the
outlet, reverse the plug. If it still does not fit, contact a qualified
electrician to install the proper outlet. DO NOT change the plug
in any way.
1. ALWAYS make sure the unit is set to the "OFF" position before
inserting the plug into a 120 volt electrical outlet.
2. Massage: To turn the unit on, simply slide the ON/OFF switch up
located on the right side of the unit. The corresponding LED light
will confirm your selection. To adjust the intensity of the massage,
slide the variable switch down for lower intensity and up for higher
intensity. (Fig. A)
4
3. Massage with Thermal Heat: Viewing the bottom side of the unit
simply twist the massage head counter-clockwise (to the left)
and pull the attachment head off (Fig. B). Locate the two red
Caution:
(heat) attachments and place them onto the post and
perpendicular to the massage unit. Once on the post, twist the
Never use
attachment clock wise (to the right) to secure. The heads should
the heat
now be aligned in the same direction as the unit (Fig. C). Slide the
feature
ON/OFF switch up and then slide the red switch up to activate the
without the
heat function. The corresponding LED light will confirm your
proper
selection. Allow a few minutes for heat to fully activate.
NOTE: To eliminate the risk of being burned, never use the
attachment.
heat function without the attachments. Do not use the thermal
heat continuously for more than 15 minutes. Do not use if you
have sensitive skin, poor circulation, discolored areas, swelling,
burned, inflamed or where skin eruptions or sores are present.
Heat should be pleasant and comfortable. Should pain or
discomfort result, discontinue use and consult your physician.
4. Apply massager head lightly to the area you wish to treat.
NOTE: Do not use the massager on one concentrated area of
the body. This massager is designed to be used with
continuous motion, constantly changing the massage area so
it is not used on one concentrated area of the body.
CAUTION - as stated in the "IMPORTANT SAFEGUARDS" section
of this manual, never use this appliance on or near eyes or other
highly sensitive areas.
5. Operation of longer than 15 minutes is not recommended and may
cause overheating.
6. When treatment is completed, turn unit off, allow to cool, unplug
the power supply and store properly in a dry place.
Figure A
Figure B
Figure C
5
Tabla de contenido
