Simu T5 AUTO+SHORT Manual Del Usuario página 3

T5 AUTO+SHORT
(230V~50HZ)
SIMU S.A.S. au capital de 5 000 000 € - Z.I. Les Giranaux - BP71 - 70103 ARC-LÈS-GRAY CEDEX - FRANCE - RCS VESOUL B 425 650 090 - SIRET 425 650 090 00011 - n° T.V.A CEE FR 87 425 650 090
These instructions apply to all T5 AUTO+SHORT drive, the different versions of which are available in the
current catalogue.
Field of application: T5 AUTO+SHORT drive are designed to drive all types of roller shutters equipped with
stop blocks and rigid links. The installer, who must be a motorisation and home automation professional, must
ensure that the drive product is installed in accordance with the standards in force in the country in which it is
installed such as EN 13659 relating to roller shutters.
Liability: Before installing and using the drive, please read operating and installation guide carefully.
Please read these instructions carefully before installing and using the drive. In addition to following the
instructions given in this guide, the instructions detailed in the attached Safety instructions document must
also be observed. The drive must be installed by a motorisation and home automation professional, according to
instructions from SIMU and the regulations applicable in the country in which it is commissioned. It is prohibited
to use the drive outside the field of application described above. Such use, and any failure to comply with
the instructions given in this guide and in the attached Safety instructions document, absolves SIMU of any
liability and invalidates the warranty. The installer must inform its customers of the operating and maintenance
conditions for the drive and must provide them with the instructions for use and maintenance, and the attached
Safety instructions document, after installing the drive. Any After-Sales Service operation on the drive must be
performed by a motorisation and home automation professional. If in doubt when installing the drive, or to obtain
additional information, contact a SIMU adviser or go to the website www.simu.com.
1 INSTALLATION
Instructions which must be followed by the drive and home automation professional installing the drive:
- Methods of wiring are given by national standards or IEC 60364 standard.
- Cables which pass through a metal wall must be protected and isolated using a sheath or sleeve.
- The cable for the motor can be removed. If it is damaged, replace by the same. The cable may only be
connected to the motor by qualified personnel. The connector is to be assembled without damaging the
contacts. The continuity of the earth connection must be ensured.
- To receive information regarding the compatibility of the motor and the roller shutter or/and accessories, contact
the roller shutter manufacturer or SIMU.
T5 AUTO+SHORT 06/17
Drilling
the tube:
45
120
Assembly :
V.A.R
V.A.S
EASYLINK
OCTOEASY
MANDATORY
5.3 Nm max
55
22,8
24
48*
4
1
364
IP44
387
1 4
2
2
3
5141822A
EN- Original instructions
i
-20°C / +60°C
351
4 x Ø5 / 90°
Ø4,8 x 10
STEEL
3 Ø5 x 10
2
1
2
3
2
1
47
min.
1
EN
1/2