Idiomas disponibles
Idiomas disponibles
EN
Connecting the fixture to 100-240 V
If you want to connect the fixture to a 100-240V power source, you
must use the separately available internal transformer. Your dealer
can advise you about this. The appliance should only be connected to
a 100-240V power source by an authorised installer.
Step 1
Remove the wall plate from the fixture by loosening the two Torx
screws. Mark the position of the two attachment holes and the square
in the wall plate on the wall. Make a hole for the cable of at least
13 mm at the location of the square (A). Attach the wall plate to the
surface using the screws supplied and plugs if necessary. (Fig. 1)
Step 2
Remove the bottom of the fixture by loosening the two socket head
screws. Position the transformer in the holder and then fix it in place
using the supplied screw. (Fig. 1a)
Step 3
Connect the internal transformer to the fixture by connecting the mini-
connector. (Fig. 4)
Step 4
Run the 100-240V cable through the opening in the housing. Reattach
the bottom of the fixture to the housing by tightening the two socket
head screws.
Step 5
Thread the 100-240V power cable of the internal transformer through
the hole (A), place the fixture over the wall plate and fix the fixture in
place by tightening the two Torx screws. (Fig. 2)
Step 6
The appliance should only be connected to a 100-240V power source
by an authorised installer. See the manual that accompanies the inter-
nal transformer.
General maintenance advice
We advise wiping the fixture down at least once a year using a clean
cloth and warm water.
Important!
Before starting maintenance switch off the power.
