Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

Motion Sensor
Model SH-5105
Features
• D
Z
™ Technology.
UAL
ONE
• Turns on lighting when motion is detected.
• Automatically turns lighting off.
• D
B
Timer.
®
UAL
RITE
• Photocell keeps the lighting off during daylight hours.
• LED indicates motion was sensed (day or night).
This package includes:
Rubber Plug
Lamp Holders
Cover
Plate
Sensor
Light Control
Mounting Bolt
2 Wire
Connectors
Plastic Hanger
Requirements
• The Light Control requires 120-volts AC.
• If you want to use the Manual Mode, the control must
be wired through a switch.
• Some codes require installation by a qualified
electrician.
• This product is intended for use with the enclosed
gasket and with a junction box marked for use in wet
locations.
© 2006 DESA Specialty Products
Light Control
2 Shells
Gasket
6 Screws
(3 sizes included)
Mounting Strap
OPERATION
Mode:
On-Time:
Test
5 Sec
Auto
1, 5, 20 min.
Manual
Until Dawn*
* resets to Auto Mode at dawn.
Note: When first turned on wait about 1
the circuitry to calibrate.
Put ON-TIME switch
on the sensor bottom
to TEST and the D
-
UAL
B
switch OFF.
®
RITE
Put the ON-TIME switch in the 1, 5,
or 20 minute position.
MANUAL MODE
Manual mode only works at night
because daylight returns the sensor
to AUTO.
Flip the light switch off for one second
then back on to toggle between AUTO
and MANUAL MODE.
Manual mode works only with the
ON-TIME switch in the 1, 5, or 20
position.
Mode Switching Summary
TEST
AUTO
MANUAL MODE
* If you get confused while switching modes, turn the
power off for one minute, then back on. After the cali-
bration time the control will be in the AUTO mode.
D
B
UAL
RITE
Light comes on half bright for selected time after dusk
(Off, 3 hr., 6 hr., until dawn). If motion is sensed, the
light turns on full bright for the ON-TIME (1,5, or 20
minutes) then returns to dim mode.
Works:
Day
Night
x
/
minutes for
1
2
TEST
ON-TIME
D
B
UAL
RITE
TEST 1 5 20
Off 3 6 Dusk to
Dawn
AUTO
ON-TIME
TEST 1 5 20
1 Second OFF
then...
... back on.
Move ON-TIME Switch to
1, 5, or 20 minutes
Flip light switch off
for one second then
back on*
TIMER
®
598-1152-01
x
x
x
®
Tabla de contenido
loading

Resumen de contenidos para Secure Home SH-5105

  • Página 1 Light Control Mode: On-Time: Works: Night Test 5 Sec Auto 1, 5, 20 min. Model SH-5105 Manual Until Dawn* Features * resets to Auto Mode at dawn. • D ™ Technology. Note: When first turned on wait about 1 minutes for •...
  • Página 2 INSTALLATION ❒ Twist the junction box wires and fixture wires together as shown. Secure with wire connectors. For easy installation, select an existing light with a wall Mounting White to Black to switch for replacement. Strap White Black Rubber Plug Mounting Wall Mount Eave Mount...
  • Página 3 TEST AND ADJUSTMENT ❒ Loosen the clamp screw in the Clamp sensor ball joint and gently Screw ❒ Turn on the circuit breaker and light switch. rotate the sensor. ❒ Walk through the coverage NOTE: Sensor has a 1 minute warm up period Ball area noting where you are before it will detect motion.
  • Página 4: Troubleshooting Guide

    TROUBLESHOOTING GUIDE SYMPTOM POSSIBLE CAUSE SYMPTOM POSSIBLE CAUSE Lights will not come Lights stay on 1. Light switch is turned off. 1. A flood lamp is positioned too close to continuously. 2. F l o o d l i g h t i s l o o s e o r the sensor or pointed at nearby objects burned out.
  • Página 5: Detector De Movimiento Y Control De Luz

    Para PRUEBA: Ponga el interruptor de ON-TIME Control de Luz ® RITE tiempo (ON-TIME), al fondo del detector, en Modelo SH-5105 TEST 1 5 20 Off 3 6 Dusk to la posición de prueba Dawn (TEST) y D ® Características RITE apagado (OFF).
  • Página 6: Instalacion

    INSTALACION lámina de Blanco a Negro a Montaje Blanco Negro Para una fácil instalación escoja una luz con un interruptor de pared. Enchufe de Caucho Perno de Montaje Montaje en pared Montaje en alero Para instalarlo bajo el alero, la cabeza del detector debe ser girada como se muestra en los dos pasos Empaquetadura siguientes para evitar el riesgo de un choque eléctrico.
  • Página 7: Prueba Y Ajuste

    PRUEBA Y AJUSTE ❒ Fije la sensibilidad (RANGE) Tornillo como necesite. Demasiada Sujetador ❒ Prenda el cortacircuitos y el interruptor de luz. sensibilidad puede aumentar las falsas alarmas. NOTA: El detector tiene un período de cerca de 1 Unión ❒ Asegure la puntería de la ca- minutos de calentamiento antes de detectar Esférica beza del detector ajustando el...
  • Página 8: Guia De Investigacion De Averias

    GUIA DE INVESTIGACION DE AVERIAS SINTOMA POSIBLE CAUSA SINTOMA POSIBLE CAUSA La Luz no se enci- 1. El interruptor de luz está apagado. l u z 1. Un faro está colocado demasiado cerca ende. 2. El faro está flojo o fundido. queda prendida al detector o apunta a objetos cercanos continuamente.

Tabla de contenido