INSTALLATION ON WINDOWS
N
ELECTRICAL INSTALLATION
1. All the wiring will have to comply with the local and national codes of electricity and
it will have to be installed by qualified personnel.
2. There must be available an individual derived circuit with a proper outlet for the
exclusive operation of this air conditioning appliance. Consult following table with information
on the capacity suggested for the cables for the derived circuit.
3. It is essential that the outlet plug that you select matches the inlet plug of the
appliance and it is within reaching distance of the installed appliance.
NOTE: The inlet cord is 57,8 inches ( 1470 mm) long and it is
attached to the lower part of the command checkerboard. DO NOT
USE a plug adapter nor an extension cord. Check Table 2 for
information on types of plugs and fuses.
4. Comply with the fuse type (Table 2) indicated in the data plate of the appliance,
located above the air discharge.
5. IMPORTANT: The wires in the principal cable are arranged according to the
following colour code:
Green and Yellow: Earth
Since the colors of the wires in the principal cable of this equipment could not
correspond to the terminals identifying colours in the plug, proceed in the following way:
the green and yellow wire must be connected to the terminal in the plug that it is labeled
with the letter E (Earth) or by the earth symbol or coloured green and yellow.
The installation on windows is recommended only in those
cases in which there is not any possibility of installing the appliance
on walls, since it can cause vibrations and noise. But, if it is the
only place available, follow these suggestions:
- You must have a iron or steel reinforced structure, French
hand type or loafer, duly measured for your appliance, similar
dimensions to those for wall installation
- Avoid all contact of the appliance with the glass panes,
supporting it with rubber cradles to avoid vibrations and noise.
Blue: Neutral
7
Brown: Phase