Important - Springer DC - R Manual Del Usuario E Instalación

IMPORTANT

Drain
wall
WALL INSTALLATION USING SPECIAL CONCRETE BOXES
- check secure and proper installation of unit casing, being sure
all supporting screws are installed and tightened. With one person
supporting each side of the unit chassis, lift chassis and slide into
unit casing. Slide in chassis all the way. (F15)
- replace front grille removed before. Install and tighten both front
grille screws.
1) Once the installation ended, confirm the slope of the
appliance is correct ( 0,5 blister - 1 cm)
2) Your appliance has a drainage for water to exit. Depending
on the place of installation, you may use a hose connected to the
drainage net of your residence to avoid water dripping from
occurring.
3) In order to keep a normal air flow through the compressor
and condenser please verify that the lateral and superior openings
of the appliance are turn outward and TOTALLY cleared.
Otherwise, your appliance may present operation problems, with
possible compressor failure. Very thick walls should be beveled
outwardly.
- follow all the previous instructions
- verify if the slope of the appliance is correct (0,5 blister - 1 cm)
- leave lateral and upper openings so the air flow within the
compressor and the condenser is normal.
6