Installing The Trufit Bubbler Housing - Jandy TruFit HCBUB Manual Del Propietário

TruFit Bubbler | Owner's Manual
2.2 Installing the TruFit
1. The TruFit Bubbler is designed to be installed during the gunite phase
of pool building.
2. Two conduits should be run to the Bubbler body:
A. 1.5" PVC Pipe for water supply and
B. 1" conduit for Pool Light Power Cord.
NOTE: Do NOT use 90 degree fittings. Only 45 degree or sweep elbows.
3. The 1.5" PVC pipe supplying the water to the Bubbler should have
a gate valve or ball valve installed to adjust the water supply flow to
create desired water/lighting effect.
4. Conduit for the TruFit Bubbler power cord must run from the bubbler
directly to a listed Junction Box certified for pool/spa luminaires, or
Listed Low Voltage Transformer certified for pool/spa luminaires and
direct conduit connection to wet-niche or no-niche luminaires.
5. With the large construction cap on, install the Bubbler Housing onto
the pipe so that the disired finished surface is above the lower indicator
(B) and bellow the top of the cap (A). See figure 4
Important: After gunite you need to "cove" around the TruFit Bubbler
Housing. This is so that the Large Construction Cover can be removed
and the adjustable sleeve can be installed and trimmed to be flush with
the interior surface.
6. Dig a cove around the top of the TruFit Bubbler Housing.
7. Trim Adjustable Sleeve to be flush with the interior surface.
NOTE: Threaded inserts on the adjustable sleeve are only used for vinyl/
fiberglass installations.
8. Install the Small Construction Cover before plastering. This ensures
the threads remain clean and no debris falls into the Bubbler Housing.
9. Backfill the "cove" area around the Bubbler Housing. After plastering,
remove the Small Construction Cover.
NOTE: Leave the O-ring in the bubbler body when removing the Small
Construction Cover to seal the pool light when it is installed.
10. Install the Jandy
11. Install the diffuser into the adjustable sleeve. Rotate until the cutouts
on the diffuser align with the pins on the adjustable sleeve.
12. Select the lens for the desired water effect. Wrap the lens O-Ring
around the lens groove. Install the lens into the adjustable sleeve and
rotate the lens until it is secured.
Bubbler Housing
TM
HydroCool Nicheless Pool Light (see Section 2.4).
®
ENGLISH
Page 9