Bayside LAGOON Manual Del Usuario página 9

Lagoon Fan Installation Instructions
OPERATING THE REMOTE:
Before you start using the remote, take the time to read through this section and get familiar with the
buttons and function of each button.
LED Indicator
The red LED indicator on the top of the transmitter will flash
when the buttons are active.
BUTTONS ON THE REMOTE
HI: Press the button to set fan running at High speed.
MED: Press the button to set fan running at Medium speed.
LOW: Press the button to set fan running at Low speed.
OFF: Press the button to turn OFF the fan.
: Press the button to turn ON/ OFF the light.
The LED light has a 3-step dimmable function which is
controlled by an ON/OFF switch.
When the LED light is ON and at 100% brightness, press the
light button "ON and then OFF within 5 seconds", to dim the
LED light. Repeat pressing ON and then OFF within 5 seconds to dim further in the following sequence:
100% brightness → 40% brightness → 15% brightness → 100% brightness.
To switch back to 100% brightness at any stage, turn OFF the luminaire, and then wait after 5
seconds turn ON the luminaire, it will reset to 100% brightness.
The remote has memory function. If the fan or light is turned off by the isolating switch, it will memorise
and recover the last status when turned on next.
8 | P a g e
Fig. 10
V1.1-EU (10/2020)