Important; Canopy Assembly - Craftmade Bellows III Guia De Instalacion

6. Wiring. (cont.)
[PLEASE NOTE: Wall and/or handheld
remote control must be used for fan to
operate. If you do not wish to use the wall
control, please proceed to Section 7 to
continue with fan installation.]
To install wall control, remove existing
wall switch. Wire one of the wall controls
with wire connectors provided as shown in
diagram at right.
*Wrap each wire connector separately with
electrical tape as an extra safety measure.
Gently push wires and taped wire
connectors into outlet box.
Install one 12-volt battery (included) in
wall control.
IMPORTANT: Wall control will not function
unless battery is installed.
Select a faceplate (white or almond) and
press firmly onto front of wall control.
Attach wall control to outlet box and
secure with screws from original wall
switch. Attach wall plate (included) to wall
control using 2 screws provided with the
wall control.

7. Canopy Assembly.

Remove 2 screws on underside of hanging bracket.
Lift canopy to hanging bracket. Align holes in
canopy with holes in hanging bracket. While
holding canopy in place, slide anti-sway adapter up
to canopy. Align holes in anti-sway adapter with
holes in bottom of canopy and then re-insert the
screws that were previously removed. Tighten both
screws securely.
Slide canopy cover up to anti-sway adapter,
aligning rounded part of slotted holes in canopy
cover with screw heads in bottom of anti-sway
adapter. Turn canopy cover to the right (clockwise)
until it stops.
*Remember that antenna for remote control
receiver must rest outside of hanging bracket.
Modifications not approved by the party responsible for compliance
could void the user's authority to operate the equipment.
*NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
* Reorient or relocate the receiving antenna.
* Increase the separation between the equipment and receiver.
* Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
outlet box
green/ green/ green/
bare bare bare
ground ground ground
black (OUT to fan)
black
black
(TO POWER supply)
black
(AC IN from
breaker box)
12V battery
(wiring for wall control)
page 6
wall control
green
antenna
hanging bracket
canopy
anti-sway adapter
canopy cover
radio
radio or television
face-
plate
plate