Strapping The Child Into The Zeus Plus - Be Cool zeus plus Manual De Instrucciones

The seat is fitted with 2 ISOFIX connectors. The
screen will indicate whether the connectors are
correctly secured (see the important note in the seat
installation section).
Support leg indicator
This symbol confirms that the leg position is correct
and that it is in contact with the floor.
If all the indicators display a"
will be displayed to confirm that the seat has been
installed correctly.
Changing the batteries
To change the batteries for the installation system
there is a compartment (13) on the underneath of
the seat base.
The system uses 2 x LR6 AA 1.5v batteries. Change
the batteries whenever the low battery warning
signal is displayed.
" then the word OK
3. STRAPPING THE CHILD INTO THE
SEAT
This child restraint system has a loading position
making it easy to place the child in the seat and
adjust the straps to fit correctly.
3a. Turn the seat to the loading position (2b) and
open the harness (5). Move the harness straps to the
sides to place the child in the seat.
Place the straps over the child and fasten the
3b.
buckle.
3c. To adjust the headrest (2) pull the lever (1) on the
top. It should be set to the right position, this means
that the shoulder harness should come out approxi­
mately 1 cm above the child's shoulders.
3d. Tighten the harness by pulling the strap (6), it
should fit the child snugly.
EN
31