4. FASTENING THE CHILD IN THE SEAT
Using the cushion insert.
Use the cushion insert from birth until the child
measures 61 cm approximately. It is advisable to use
the cushion insert after the child is bigger than 61 cm,
provided that it is compatible with the baby's size.
Putting the child in the safety seat.
4a.
Open the buckle by pressing the red button,
separating the connectors to make it easier to put the
child in..
4b.
Settle the child comfortably in the seat, and put the
safety harness on fastening the buckle.
4c.
To adjust the headrest, open the compartment on
the back of the baby carrier. Move the seat belt guide
(2) upwards to let the compartment drop open.
4d.
Press the lever to adjust the height of the headrest.
IM 2041,00 ONE instruc ok.indd 27
It should be placed in the right position, this means
4e.
that the harness should come out approximately 1 cm
above the child's shoulders
4f.
again.
4g.
Once the child is positioned correctly, tighten the
harness by pulling the strap making sure that it fits
snugly.
The correct tension means that between the harness
strap and the baby's chest there should be a gap of
no more than 1 cm. (just enough to slide one finger
between the baby and the harness).
Getting the child out of the safety seat.
Loosen the harness straps by pressing the tension
4h.
button. Then unfasten the buckle and lift the child
out
4a.
WARNING! The straps must not be twisted. The harness
must be correctly fastened and the straps should fit
the child snugly.
Close the compartment
31/1/19 16:52
EN
27