HUMIDIFIER FUNCTIONALITY SERIES K
•
Pull the water tank out from the side of the purifier.
•
Remove the package of the humidifying filter.
•
Put the humidifying filter into the water tank.
•
Open the rubber lid of the inlet.
•
Add about 1L cold water through the inlet, filling around 80% of the water tank.
•
After adding water, close the lid.
•
Push the tank back into the purifier.
•
This machine has evaporative humidifying function.
•
If water is added into the water tank, the machine will generate steam automatically.
The humidification effect is related to the wind speed, and it works better when the machine is
operating at a higher gear. If the water level becomes low, the indicator light will flash while the
machine continues working normally. If the water tank is taken out, the indicator light will stay on,
and the machine will stop working.
FILTER STATUS
SERIES F Please press the "Child Lock" button till the display show the filter accumulated time.
SERIES K When the machine is on, press "Reset" button and the total working time will be shown in hours
on the screen. This equals a check of working time. Since the screen can only display three
figures, the thousands digit will be displayed first, then hundreds, tens and single. This machine
has a regular reminding function of filter replacement, which works every 320 hours and 1500
hours. After every 320 hours, the indicator light on the panel will flash to inform users to clean
the filter No.1
Into APP product page there is the Total Filter Time.
REPLACING THE FILTERS
Release the front panel, referring to the Filter Installation section. Remove the front panel and remove
the filters one by one.
Reinsert the new filters one by one in the correct sequence (and towards):
•
Pre-filter: Clean the filter every 15 days and replace it every 2 years.
•
Carbon / Catalytic Filter: Clean the filter every 60 days and replace it every 6/12 months.
•
Antibacterial / HEPA filter: Clean the filter every 60 days and replace it every 6/12 months.
ITA
EN
05