Tetra Tetronic LED ProLine 380 Instrucciones página 12

UK
Placing the LED light on the edge of the aquarium
The multi adapters are required for this attachment option. The
light can be placed on aquariums with an edge thickness of
4 – 10 mm.
Procedure:
Fig. B
1. Place the multi adapters over the bayonet connectors on the
extension arms.
2. Rotate the multi adapters by 90° until they click into place.
– Turn the assembly so that the open sides of the multi
adapters face the edge of the aquarium.
3. Push the extension arms into the openings at both ends of
the LED light.
– The teeth on the extension arms must point towards the
lamp.
4. Adjust the extension arms to the required length and
carefully press the LED light onto the edge of the aquarium
until it sits securely.
– The arms must not be extended by more than 12.5 cm on
either side of the LED light.
Placing the LED light in the light bracket for fluorescent tubes
The T5 or T8 adapters are required for this attachment option.
Condition:
• The bracket is compatible with T5 or T8 fluorescent tubes.
The union nuts with seals for attaching the fluorescent tubes
are needed to attach the LED light and seal the bracket.
Procedure:
Fig. C
1. Place the T5 or T8 adapters over the bayonet connectors on
the extension arms.
2. Rotate the adapters by 90° until they click into place.
– The adapters must be positioned above the light unit.
3. Push the extension arms into the openings at both ends of
the LED light.
– The teeth on the extension arms must all point towards the
lamp.
4. Place the union nuts onto the T5 or T8 adapters.
5. Pull out the extension arms until the T5 or T8 adapters on
both sides are flush with the bracket.
– The arms must not be extended by more than 12.5 cm
each.
6. Hold the LED light between the bracket, twist the union nuts
onto the bracket and hand-tighten by turning clockwise.
12
Tetronic LED ProLine 380/580/780/980