Quick Start; Menu Operation - DeFelsko PosiTector 6000 Manual De Instrucciones

Press the
life, the gage will automatically go to sleep after 5 minutes of
inactivity. While in Sleep Mode, the gage powers up significantly
faster— convenient when moving between parts or locations. The
gage will completely power off after 4 hours of inactivity.
Alternatively, select Power Off from the main menu. All settings
are retained.
1. Remove the protective rubber cap (if supplied) from probe.
2. Power-up Gage by pressing the center navigation button
3. Verify accuracy and adjust if necessary (pg. 3).
4. Place the probe FLAT on the surface to be measured.
HOLD STEADY. When a valid measurement is obtained,
the Gage BEEPS twice and the measurement is displayed.
5. Lift probe AT LEAST 2 INCHES (5 cm) from the surface
between measurements - OR - leave probe on the surface
in the same location for continuous measurements.
To access the Menu, power-up the gage, then press the center
navigation button
used to navigate the menu. If desired, touch screen functionality
can be disabled within the Setup menu (See Touch, pg. 8).
Select a menu option by touching it, or use the
tons to highlight the desired option and press
On menus longer than one page, the current page number is dis-
played below the menu name. Navigate between pages using
when the first menu item is selected, or
menu item is selected. If using touch, navigate between pages
by touching
Introduction

Quick Start

button to power up the Gage. To conserve battery

Menu Operation

. Either the keypad or touch screen can be
or , or by swiping up or down.
1
and but-
to select it.
when the last
.