Tabla de contenido
Idiomas disponibles
Idiomas disponibles
SQUARE CABINET
Items Needed:
Socket Wrench
7/16-in Deep-well Socket Square
Process:
• Square the cabinet and wrench tighten all bolts.
NOTE: be sure all hardware is fully seated
before tightening.
Figure 7
DOOR CONSTRUCTION
Items Needed:
GG - #10-24 Hex Nut (Qty: 8)
MM - Lower Hinge Pin (Qty: 2)
EE - #10-24 Carriage Bolt (Qty: 8) LL - Upper Hinge Pin (Qty: 2)
Socket Wrench
Note: The hinges for both Doors MUST be mounted so the
Hinge Pin points UP at the TOP of the door and DOWN at
the BOTTOM of the door.
• Attach the LL and NN hinges to the doors using (8) EE
(8) FF and (8) GG.
• Wrench Tighten.
Figure 8
Process:
• Make sure to insert Hinge Pins through slots.
FF
GG
E
LL - Door E
MM - Door F
PP - 5/32-in Hex Key
FF - 3/16-in Washer (Qty: 8)
3/8-in Deep-Well Socket
EE
MM - Door E
LL - Door F
Figure 8.1
DOOR HINGE ATTACHMENT
Items Needed:
AA - 1/4-20 x 5/8-in Carriage Bolt (Qty: 4)
CC - 5/16-in Washer (Qty: 4)
DD - 1/4-20 Serrated flange Nut (Qty: 4)
NN - Unit Hinge (Qty: 2)
7/16-in Deep Well Socket
Process:
• Slide the left door hinge pin MM into the left lower hinge
NN. (See Figure 9., lower left detail).
• Slide the hinge plate NN onto the upper door hinge
pin LL. (Figure 9.1)
• Attach the left door E as shown, by mounting the upper
hinge NN, using (2) AA, (2) CC and (2) DD.
• Attach the right door F in the same manner.
AA
NN
Figure 9
NN
Figure 9.1
6
CC
DD
Tabla de contenido
