Baja motorsports AT150SS Guía De Armado página 7

INSTALLING WHEELS
When correctly installed, the tread pattern on the wheels face
forward when looking at the wheel from the top.
 Locate wheel hardware as described in the Loose Parts
List on page 5.
 Lift front of ATV and install front tires using lug nuts
provided (4 for each wheel). Tighten the lug nuts securely
in a crisscross direction.
NOTE: The unit is heavy. Get help as needed.
 Lift rear of ATV and install rear tires using lug nuts provided
(6 for each wheel). Tighten the lug nuts securely in a
crisscross direction.
NOTE: The ATV can now be rolled off the bottom of the metal
packing frame.
 Torque lug nuts to 35 ft.lbs. (47 Nm).
WARNING:
Strictly adhere to all torque wrench tightening specifica-
tions. Failure to do so could cause serious personal injury.
WARNING:
If any parts are damaged or missing do not assemble
this product until the parts are replaced with new original
manufacturer's parts or their equivalent. Assembly of this
product with damaged, missing, or incorrect parts could
result in serious personal injury.
ASSEMBLY
 Install hub caps on all wheels.
 Check the air pressure of the tires and inflate as needed
to the proper amount.
NOTE: Tire pressure should only be measured or
adjusted when tires are cold.
WARNING:
Check the tire pressure carefully while inflating. Too much
air in the tire could cause the tire to burst, causing serious
personal injury.
WARNING:
Maintaining correct air pressure in the tires is very impor-
tant. Too little pressure could allow the tire to rotate off
the wheel rim. Too much pressure could cause the tire to
burst. Failure to maintain correct air pressure in the tires
could cause problems with vehicle operation and stability,
causing serious personal injury.
7 — English
Recommended Pressure
3.6 psi ± 0.5 psi
(25 kPa ± 3.5 kPa)
© 2010 Baja, Inc. All Rights Reserved.