Tabla de contenido
Electric installation manual
ATTENTION! The electric power supply circuit of the hoist must contain a
switch for safety purposes and emergency de-energization. The switch is not
supplied.
1. The supplied U-shaped ring can be attached to the lighting fixture. The technical
parameters of the bolts should comply with the following requirements:
Bolt М1о is used for lighting fixtures under 150 kg.
The bolt should comply with the requirements for hexagonal bolts - class С
GB/f5780-1986.
Voltage supply and safety measures.
1. Connect the phase, neutral wire and earthing of the input power supply to the
220 V AC current.
Schematic diagram of connection to the power supply input
(Diagram 1)
L1 Phase
L2 Phase
Schematic diagram of connection to the power supply output
(Diagram 2)
EN
22
Junction box
Earthing
N Neutral
Black N connected
with neutral wire
Blue L2 connected
with the phase
Red L1 connected
with the phase
2. The power supply wire of the lighting fixture should be connected with the lower
conductor of the hoist as shown in the schematic diagram 2.
For connecting lighting fixtures with separate energization lines. Connection goes
separately for L1 and L2.
З. Make sure that the external wires are properly placed on the lighting fixture
terminal to eliminate contact with the surrounding metal conductor and avoid
power leakage.
4. When connecting to the terminal block, please, double-check and tighten the
stamped screws one after another to make sure that the connection is secure.
ATTENTION!
Before maintenance, make sure that the lighting fixture switch is set
џ
on "Off", as the hoist may still be under voltage even it has been
stopped.
Keep oil, water and metal away from current carrying elements of
џ
the hoist.
Remote control user's manual
Operation
indicator
Move
«Up»/ Stop
Move
«Down»/ Stop
Battery
If the indicator on
the panel is dim or
the remote control
is not working
properly, please,
replace the battery.
23
EN
Tabla de contenido
