Operation - Mitsubishi Electric MA-E100R-E Manual De Instrucciones

Operation

Select from Manual operation (three air volume levels) and Auto operation (Normal and Night).
1
Insert the power plug into the power outlet.
When the power plug is inserted, the i-see Sensor operates and then stops when it faces forward. Furthermore, the main unit turns to face
forward.
2
Start the operation.
l All of the lamps flash twice.
Blip
l Operation switch lamps light up.
l An operation mode lamp lights up.
l The louvre opens and blowing starts.
Press
3
Change the operation.
„ For operation with a constant air volume
(Manual)
Press
Air volume (Low/Middle/High)
l A person is located by i-see Sensor and then efficient
air flow is created by AUTO TURN.
l The louvre stops at the optimal angle.
4
End the operation.
Bleep
Press
l Each press changes the
operation mode, and the
lamp for the selected
operation mode lights up.
High
Low
l The operation switch lamps go out.
l The operation mode lamp goes out.
l The louvre closes.
ATTENTION
Press the power switch after i-see Sensor and AUTO TURN
stop. (If operation does not start after pressing the power
switch, press it again.)
Response will be slow for a few minutes after the power switch
is turned ON because the PM2.5 Sensor and odor sensor are
performing the preparation operation.
„ For automatic operation according to level of
contamination (Auto)
Press
Normal
l This is the standard
automatic operation.
The air volume is
changed automatically.
l A person is located
by i-see Sensor and
then efficient air flow
is created by AUTO
TURN.
l The louvre operates
according to the person's
location detected.
NOTE
When dust or odor is detected, the air volume and sound change.
l The i-see Sensor and the main unit automatically face forward.
l The operation mode is remembered even if the power switch is
turned OFF or the power plug is disconnected.
l Each press changes the
operation mode, and the
lamp for the selected
operation mode lights up.
Night
l Operation is performed
automatically while
keeping the air volume
low.
l The control panel lamps
and the clean monitors
are dimmed slightly.
l The i-see Sensor and
AUTO TURN do not
operate.
l The louvre stops at the
optimal angle.
11