5.
INSTALLATION
INSTRUCTIONS
•
This unit was developed specifically to be installed at vehicle
roofs. For determining the vehicle´s requirements, where to the
system is to be installed, the following should be considered:
1)
Sealing area size; and
2)
The amount of roof insulation to be used at the roof walls
(material not included).
How to install
1)
Mark and carefully cut out a roof opening (if necessary);
2)
Cover the inner and outer edge of the sealing strip with a
non-hardening plastic butyl sealant, for example: SikaLasto-
mer-710 or Silicone (not included);
3)
Set and centralize the system to be installed at the roof hatch
opening;
4)
Maintain the product´s structure integrity, otherwise, damage
may occur;
5)
Align the Unit to be installed with the vehicle´s roof, otherwise,
water may accumulate and cause leakage;
6)
Insert the inner cover.
22
Electric Automotive Rooftop System - A/C - Green 15.000 BTU 24V - DS630054
Electrical installation
•
Before installing the Electrical Rooftop A/C System, check if all
components are turned off and unplugged;
•
Connect the 30-ampere Rooftop A/C Green Unit to the vehicles
electric grid;
•
Use the vehicle´s distributor module or connect the cable of the
Rooftop A/C Green Unit to the battery. In the last case, connection
should be made directly from the battery´s main terminal.
•
Connect the red cable to the positive pole and the black cable to the
negative pole of the system;
+
-
•
And, connect the voltage supply cable with a clamp at the cabin´s
roof.
- THE TOTAL LENGTH OF THE POWER CABLE SHALL NOT BE LONGER
THAN 5 METERS;
- THE BATTERY SHOULD PROVIDE THE NECESSARY CURRENT AND
ELECTRIC POWER FOR THE SYSTEM TO RUN;
- THE ROOFTOP AIR-CONDITIONING SYSTEM HAS ALREADY BEEN
PRESSURIZED WITH REFRIGERANT FLUID R134A AND OIL ISO VG 68.
DS630054 - Electric Automotive Rooftop System - A/C - Green 15.000 BTU 24V
- Use a 10mm-cable and an 80A
(+) blade fuse. (Battery cable not
included).
NOTE:
23