Tabla de contenido
Idiomas disponibles
Idiomas disponibles
7. Canopy Assembly.
Raise canopy to hanging bracket and align
slotted holes in canopy with loosened screws in
hanging bracket. Twist canopy to lock. Re-insert
screws with washers that were previously
removed (page 3, Section 4) and secure all
screws with Phillips screwdriver.
*Remember that antenna for remote control
receiver must rest outside of hanging bracket.
8. Light Kit Assembly.
Install the 100-watt mini can halogen bulb, type
JD E11, provided.
Tip: Do not touch glass portion of bulb with fingers
or hands. Oil from skin can cause bulb to overheat
and go out prematurely. Use cardboard box or
foam wrapping bulb was packed with to layer
around glass portion of bulb.
Locate slots on glass shade and align with
dimples on fitter plate (located on underside of
motor housing). Slide glass shade onto fitter
plate and gently turn glass shade in a clockwise
direction until it slides into place.
IMPORTANT: The glass shade must be removed
in order to replace the bulb. When you need to
replace the bulb, please allow bulb and glass
shade to cool down before touching. Use one
100-watt max. halogen bulb, type JD E11, to
replace the bulb, keeping in mind not to touch
the bulb itself as described above (see "Tip").
antenna
slotted
hole
bulb
page 7
hanging bracket
canopy
dimple
fitter plate
glass shade
Capítulos
Tabla de contenido
