Tabla de contenido
To confirm the correct position of the centre brush, you need to keep the machine still,
in the same place with the brush rotating for 15 - 30 seconds and then, after having
switched the machine off (always keeping it still), move forward to find the area of
contact of the brush on the ground, measuring the print on the ground, a good
adjustment should a width of 3-4 cm on the ground print (see fig.13).
MANUAL DE INSTRUCCIONES Y
MANTENIMIENTO
KB110GT
fig. 12
fig. 13
25
Pág.
N° MUM 004
Rev. 0
Tabla de contenido
