Tabla de contenido
Antes de prender la maquina:
Tire la Mesa Movble No. 08 (FIg.01) totalmente para la frente de la maquina
Coloque el producto a ser cortado sobre la Mesa Movible.
Elija la espesura de la tajada a ser cortada y ajuste el Regulador de Corte No. 10 (Fig. 01).
Ajuste la Guía de la Hoja No 06 (Fig.01) para que su altura sea la altura de la pieza a ser
cortada, no mas.
Colóquese en frente a la maquina para poder mirar de frente la Hoja
Prenda la Maquina
Para prender la maquina presione la llave Prende/Apaga para la posición "I"
.
Agarre la Mesa Movible No. 08 (Fig.01) con la mano izquierda y empuje la mesa en dirección
a la ,Hoja .cortando el producto en velocidad constante.
Después de cortar la tajada re rela con la mano derecha.
La tajada deberá ser removida SIEMPRE por atrás de la Hoja para evitar el contacto de la
mano con la Hoja.
Coloque las tajadas sobre la Mesa Fija No. 11 (Fig.01)
Vuelva la Mesa Movible para la frente de la maquina y repita los pasos anteriores hasta
cortar todo el producto;
Al terminar la ul ma tajada apague la maquina presionando la Llave Prende/Apagano. No.
02 (Fig. 01) en la posición "O"
Nunca re re las tajadas por la frente de la maquina.
32
IMPORTANTE
4. GENERAL SAFETY PRACTICES
If any recommenda on is not applicable to your equipment , please ignore it .
The following safety instruc ons are addressed to both the operator of the machine as
well as the person in charge of maintenance.
The machine has to be delivered only in perfect condi ons of use by the Distributor to the
user. The user shall operate the machine only a er being well acquainted with the safety
procedures described in the present manual. READ THIS MANUAL WITH ATTENTION.
Any change in the protec on systems and safety devices will during opera on,
create serious risks to the operator physical integrity
4.1 Basic Opera on Procedures
4.1.1 Dangers
Some areas of the electric device have parts that are connected or have parts connected
to high voltage. These parts when touched may cause severe electrical shocks or even be
lethal.
Never touch manual commands such as switches, bu ons, turning keys and knobs with
your hands wearing wet clothes and/or wet shoes. By not following these instruc ons
operator could be exposed to severe electrical shocks or even to a lethal situa on.
4.1.2 Warnings
* The operator has to be well familiar with the posi on of ON/OFF Switch to make sure the
Switch is easy to be reached when necessary.
* Before any kind of maintenance, physically remove plug from the socket.
* Provide space for a comfortable opera on thus avoiding accidents.
* Water or oil spilled on the floor will turn it slippery and dangerous. Make sure the floor
is clean and dry.
* Before using any commands (switch, bu ons, lever), be sure it is the correct one. In case
of doubt, consult this manual.
* Never touch any manual commands (switch, bu ons, lever) unadvisedly.
* If any work is to be made by two or more persons, coordina on signs will have to be
IMPORTANT
IMPORTANT
17
Tabla de contenido
