Jump Starting; Cutter Blades; Blade Sharpening - Scag Power Equipment SWZ Serie Manual Del Operador

R
Charging rates between 3 and 50 amperes are satisfactory
if excessive gassing or spewing of electrolyte does not
occur or the battery does not feel excessively hot (over 125°F). If spewing or gassing occurs or the temperature
exceeds 125°F, the charging rate must be reduced or
temporarily stopped to permit cooling.
B. JUMP STARTING
1. The booster battery must be a 12 volt type. If a
vehicle is used for jump starting, it must have a
negative ground system.
2. When connecting the jumper cables, connect the
positive cable to the positive battery post, then
connect the negative cable to the negative battery
post.
7.8

CUTTER BLADES

A. BLADE INSPECTION
1. Remove the ignition key before servicing the blades.
2. Raise the mower deck to the highest position. Place
the lanyard pin in the highest cutting height position
to prevent the cutter deck from falling.
WARNING
Always wear proper hand and eye protection when
working with cutter blades.
3. Check the cutter blades for straightness. If the cutter
blades appear bent, they will need to be replaced.
WARNING
Do not attempt to straighten a bent blade, and
never weld a broken or cracked blade. Always
replace it with a new blade to assure safety.
4. If a blade cutting edge is dull or nicked, it should be
sharpened. Remove the blades for sharpening. See
"Blade Replacement."
Keep the blades sharp. Cutting with dull blades not
only yields a poor mowing job, but slows the cutting
speed of the mower and causes extra wear on the
engine and the blade drive by pulling hard.
B. BLADE SHARPENING
If possible, use a file to sharpen the blade. Using
a wheel grinder may burn the blade.
DO NOT sharpen the blades beyond 1/3 of the
width of the blade. See Figure 7-3.
1. Sharpen the cutting edge at the same bevel as the
original. See Figure 7-3. Sharpen only the top of the
cutting edge to maintain sharpness.
Do Not Cut In
30
Figure 7-3.
2. Check the balance of the blade. If the blades are out
of balance, vibration and premature wear can occur.
See your authorized Scag dealer for blade balancing
or special tools, if you choose to balance your own
blades.
30
Section 7
- NOTE -
- NOTE -
- NOTE -
Angle Blade Back
X Must NOT Exceed
1/3 Blade Width

Blade Sharpening

SGB033