Steam Function - LG WKEX200HA Serie El Manual Del Propietario

Problem
Lint on clothes. Lint filter not cleaned properly.
• Remove the lint from the filter before every load. With the lint removed, hold the filter up
Laundry not sorted properly.
• Some fabrics are lint producers (i.e., a fuzzy white cotton towel) and should be dried
Excess static in clothes.
• Use a fabric softener to reduce static electricity. Be sure to follow the manufacturer's
The appliance is overloaded.
• Divide extra large loads into smaller loads for drying.
Tissue, paper, etc., left in pockets.
• Check pockets thoroughly before washing and drying clothes.
Excess static in Fabric softener is not used or is used incorrectly.
clothes after drying.
• Use a fabric softener or the Reduce Static option, if available, to reduce static electricity.
Clothes dried too long (overdried).
• Overdrying a load of laundry can cause a buildup of static electricity. Adjust settings and
Drying synthetics, permanent press, or synthetic blends.
• These fabrics are naturally more prone to static buildup. Try using fabric softener, or use a
Clothes have damp Very large load or very small load. Single large item such as a blanket or comforter.
spots after a dry
• If items are too tightly packed or too sparse the sensor may have trouble reading the
cycle.
• Large, bulky items such as blankets or comforters can sometimes wrap themselves into a
• To dry a few remaining damp items from a very large load or a few damp spots on a large

Steam Function

Problem
Water drips from This is normal.
nozzle when Steam
• This is steam condensation when Steam cycle starts. The dripping water will stop after a
cycle starts.
Steam does not Water level error.
generate, but no
• Unplug dryer and call for service.
error code is shown.
Water drips from This is normal.
door during Steam
• Condensation will normally form on the inside of the dryer door during steam operation.
cycle.
to a light to see if it is dirty or clogged. If it looks dirty, follow the cleaning instructions in
the MAINTENANCE section. With some loads that produce high amounts of lint, it may be
necessary to clean the filter during the cycle.
separately from clothes that are lint trappers (i.e., a pair of black linen pants).
instructions. Overdrying a load of laundry can cause a buildup of static electricity.
Be sure to follow the manufacturer's instructions.
use a shorter drying time. Select a lower dry level setting, if necessary.
lower dry level setting and/or shorter time settings.
dryness level of the load. Use a Time Dry cycle for very small loads.
tight ball of fabric. The outside layers will dry and register on the sensors, while the inner
core remains damp. When drying a single bulky item, it may help to pause the cycle once
or twice and rearrange the item to unwrap and expose any damp areas.
item after a sensor cycle has completed, empty the lint trap, and then set a Time Dry cycle
to finish drying the item(s).
short time.
Some condensation may drip out the bottom of the door.
Possible Cause & Solution
Possible Cause & Solution
TROUBLESHOOTING 55