MESTO MAXIMA 3238 Instrucciones De Uso página 13

GB IRL
10 Trouble Shooting
Fault Cause
Pressure will Pump or
not build up in screw cap
the tank. not on tight
enough.
O-ring on
pump or
screw cap
faulty or not
greased.
Piston washer
faulty.
Liquid Valve disc
escapes contaminated
through the or faulty.
Pump.
Pressure Filter and/
present, but or nozzle
nozzle will not blocked.
spray.
The nozzle Nozzle insert
produces a missing.
jet, not an
atomizing
cone.
Discharge O-rings on
valve will not pressure pin
close. not greased /
lubricated.
The liquid es-
Pressure
capes before
pin (O-ring)
the lever is
faulty.
squeezed.
Use original parts only!
Some contained in spare parts pouch (1a).
Further information is available at:
www.mesto.de
0815
AUS USA
11 Warranty
This product is covered by warranty in
Solution
accordance with the warranty regulations
Tighten pump
applicable in your country. Wearing parts
or screw cap.
such as seals, O-rings, piston washers etc.
and defects resulting from improper use are
excluded from the warranty.
Replace or
If a defect occurs during the warranty period,
grease O-
please contact us immediately (www.mesto.
ring.
de).
We will require your invoice or receipt as
proof of purchase.
Replace
piston washer
12 DECLARATION OF CONFORMITY
(Fig.19 – 21,
according to EC Machinery Directive
25).
2006/42/EC, Appendix II, No. 1A.
Clean or
We,
replace valve
MESTO Spritzenfabrik
disc
(Figure 26).
Ernst Stockburger GmbH
Clean filter
Ludwigsburger Straße 71
and/or nozzle
D-71691 Freiberg,
(Fig. 23+24)
declare under our sole responsibility that the
products pressure spraying devices of the
Place nozzle
series 3238 from factory number 1201 in the
insert into the
version supplied comply with all relevant pro-
nozzle.
visions of the Directive 2006/42/EC. Further-
more, the device complies with the Directive
97/23/EC for pressure equipment.
Grease
Rolf Rehkugler, Ludwigsburger Str. 71,
O-rings on
D-71691 Freiberg, is authorized to compile
pressure pin
the technical documentation.
with lubricant
(Figure 27).
Freiberg, 15.12.2011
Replace
pressure pin.
Bernd Stockburger
- Managing Director –
Original operating instructions
13
NZ CDN IND
6893000