Kohler K-9053 Guia De Instalacion página 6

Complete the Installation (cont.)
Install the faucet and drain trim according to the manufacturer's instructions.
If applicable, install the grab bar(s) to the backing in the stud wall (previously installed) according
to the manufacturer's instructions.
Install the shower door according to the manufacturer's instructions.
Install the finished floor.
Apply silicone sealant along the front edge of the receptor where it meets the floor.
5. Clean-Up
Consult the care and cleaning directions in the Homeowners Guide before cleaning the unit.
When cleaning up after installation, do not use abrasive cleansers, as they might scratch and dull
the product surface.
Remove stubborn stains, paint, or tar with turpentine or paint thinner.
To avoid product damage, do not allow cleaners containing petroleum distillates to remain in
contact with the product surfaces for any length of time.
Remove plaster by scraping the surface with a wood edge. Do not use metal or wire tools. Use a
powder type detergent on a damp cloth to provide mild abrasive action to the residual plaster.
1069569-2-D 6 Kohler Co.