Intended Use; Identification Plate; Transport And Storage - Wolf Garten Lycos 40V Instrucciones De Funcionamiento Originales

Intended use

Intended use
The power pack is intended for use in
corresponding Lycos 40 WOLF-Garten
battery tools and accessories. Any other
use is classed as an unintended use. The
user is liable for any damage arising from
unintended use.

Identification plate

Position
The identification plate is located at the
power pack casing.
Note
The identification is considered
as a document. It must never be
altered or obliterated.
Layout
MTD Products AG
Industriestraße 23
D-66129 Saarbrücken
LYCOS 40/XXX X
49XXXXXX650
XXXXXXXXXXX
Nominal voltage / capacity: 36V
Max. charge voltage:
Max. charge current:
1 CE label
2 Manufacturer
3 Model name
4 Model number
5 Serial number
6 Read instruction manual
7 Rated voltage / current type
8 Recycling symbol
9 Battery/power pack designation
10 Cell type
11 Capacity / Energy
12 Maximum charging voltage
13 Maximum charging current
14 Disposal instruction
15 Year of manufacture
16 Lithium-ion power pack
Rechargeable
Li-Ion Battery Pack
XXXXXXXXXXXX
XXXXXXXXXXX
/ XXAh / XXXWh
42V
XXA
XXXX
7 8
Note
The power pack is available in
three versions:
• 2,5 Ah (90 Wh)
• 5,0 Ah (180 Wh)
• 7,5 Ah (270 Wh)

Transport and storage

Transport
Note
Li-ion power packs and batteries
are subject to the requirements
of the dangerous goods act. The
user can transport the power
packs by road without further doc-
umentation. If sending via a third
party (e.g. airfreight or freight for-
warding) special requirements in
respect of packaging and labelling
must be observed. In this case,
refer to a hazardous goods expert
for preparation of the package.
Only send the power pack if the casing
Î
9
is undamaged.
10
- Apply insulating tape to open contacts.
11
- Pack the power pack so that it cannot
12
move within the package.
13
It may be necessary to adhere to other
Î
14
related national regulations.
15
Storage
16
Note
The power pack should have a
charge status of around 30% to
50% when going into storage (two
LEDs illuminate).
Charge the power pack before storage.
Î
Charge the power pack after a long
Î
period of disuse.
Store the power pack and charger
Î
separately.
Store the power pack in a cool and
Î
dry location (recommended storage
temperature approx. 0 °C - 23 °C).
EN
11