Setting The Demo Mode - Sony PC-3000 Manual De Instrucciones

Setting the DEMO Mode

You can use the DEMO mode after you set the order
and the period to display the signal of the output
channel. Set the channel and the period according to
the following steps.
1
Turn on the power.
2
Press the CONTROL button.
3
Press the > or . button until the CONTROL
MENU DEMO MODE SETTING display appears.
CONTROL MENU
DEMO MODE SETTING
4
Press the SET button.
DEMO MODE SETT I NG
No. 1 CH1–1 00M I N
5
Press the ? or / button to flash No. 1 (ex. "1").
6
Press the > or . button to set the order of the
output (No. 1 to No. 17) and the ? or / button
to move flashing.
7
Press the > or . button to select the output
channel and the ? or / button to move flashing.
DEMO MODE SETT I NG
No. 1 CH1–2 00M I N
8
Press the > or . button to set the period. Press the
? or / button to move the flashing to the next
*.
You can set the period from 0 to 99 min.
DEMO MODE SETT I NG
No. 1 CH1–2 10M I N
Note
When 00MIN is set, the channel is not output and it
skips to the next channel.
9
Press the SET button to enter the setting.
10
To set other channels, repeat the steps 5 to 9.
Displaying the signal by using the DEMO
mode
1
Turn on the power.
2
Press the CONTROL button.
3
Press the > or . button until the CONTROL
MENU DEMO MODE display appears.
CONTROL MENU
DEMO MODE
4
Press the SET button.
DEMO MODE
>ON >OFF
5
Press the ? or / button to flash ON.
6
Press the SET button to enter the setting.
The signal is output in the preset order.
21
(EN)