Tabla de contenido
Idiomas disponibles
Idiomas disponibles
RAM BOX BED COVER INSTALL
4.0 COVER LATCHING at the
REAR/TAILGATE END.
Close the tailgate and unfold
4.1
the cover. Check that the
cover is parallel and square
with the truck bed and bed rails.
If not parallel or square,
open the cover and loosen the
cab clamps to reposition
the cover.
NOTE: When opening the cover,
be sure to stow the tail clamps
into the cover bow to prevent
damage to the tarp when folded.
4.2
Open the tailgate, swing the tail clamps (1) down from the stowed position and slide them toward
the truck bed rail. Swing the clamps and pull down so the clamp jaw is under the edge of the
extrusion rail. Check that both clamps are tight.
5.0 INSTALLATION COMPLETION Installer to fold this I-Sheet and place it in the vehicle's glove box.
February 14, 2019
www.mopar.com
1
4
K6862995
Tabla de contenido
