Battery Change - CEAG EE 11 PL Serie Instrucciones De Uso

9.1Battery change

Only change batteries outside the hazardous area for explosive
atmospheres.
Use only original spare battery set from Cooper Crouse-Hinds
- Open the light fitting as shown in point 6.2
- Remove the internal tray according to section 6.2.1
- Disconnect the plug terminal
- Cut the fasteners that hold the battery pack.
- Install the new battery pack and secure it with the fasteners
- Connect the battery cables to the corresponding terminals; be careful
with the polarity of the wires and the proper tightening of the terminals.
Over tightening can affect the connection.
After battery replacement put the luminaire into operation according to 6.5.
Warning
To avoid the risk of fire, explosion, or electric
shock, this product should be installed,
inspected, and maintained by a qualified
electrician only, in accordance with all
applicable electrical codes.
Subject to alteration or supplement of this product without any advertisement before.
Save these instructions for future reference.
10 Disposal / Recycling
When the equipment or their parts is disposed of, the respective valid national
regulations on waste disposal shall be observed. In order to facilitate the
recycling of individual components, plastic parts are provided with the
identification mark of the plastic material used.
There are NiCd batteries as part of this light fitting. Control with the local
authorities for their correct recycling or disposal.
All statements, technical information and recommendations contained herein are based on
information and tests we believe to be reliable. The accuracy or completeness thereof are not
guaranteed. In accordance with Crouse-Hinds "Terms and Conditions of Sale" and since
conditions of use are outside our control, the purchaser should determine the suitability of the
product for his intended use and assumes all risk and liability whatsoever in connection therewith.
Cooper Crouse-Hinds, S.A.
8/8