Thicknessing; Working Conditions For Thicknessing; Converting Machine To Thicknessing Function - HOLZMANN MASCHINEN HOB 260ABS Instrucciones De Servicio

17.8 Thicknessing

It is necessary to modify/adjust the machine before using as a thicknesser.
Before carrying out any modification, the machine must be switched off and secured
against being switched on again.

17.8.1 Working conditions for thicknessing

 Long, protruding workpieces must be sufficiently supported! Use suitable aids such as
roller blocks etc. for this purpose. If you do not follow these instructions, there is a danger
of the workpiece being raised up quickly and/or the machine being tilted!
 Use the thicknessing function only to reduce the thickness of a workpiece with an already
surface planed facing!
 For workpieces with a difference in thickness, the chip removal must be measured at the
maximum thickness and the workpiece machined with this side first.
 Make sure that the workpiece to be machined is free of foreign objects and/or knots in
order to avoid dangerous fractures.
 Only plane workpieces that rest firmly on the machine and can be guided safely!
 If several workpieces are to be processed in series, all pieces of the same thickness should
be run through in succession without changing the setting.
 Perform the machining process from the beginning until the desired thickness is achieved.

17.8.2 Converting machine to thicknessing function

HOLZMANN MASCHINEN GmbH
NOTICE
WARNING
1. Disassembly planer fence
www.holzmann-maschinen.at
 First remove the planer fence (1) by loosening
the fixing lever (2).
 To dismantle the dust collector in the position for
planing, pull out the two brackets (6).
OPERATION
49
HOB 260ABS