Names Of Parts; Installation; Operation - Proline TTL 120 P Manual De Instrucciones

EN
NAMES OF PARTS
1. Top cover
2. Thermostat and light assembly
3. Shelf
4. Crisper cover
NOTE: The appliance design is subject to change without prior notice.
INSTALLATION
Position the appliance and allow it to stand for two to three hours before it is turned on for the first time
to allow the system to settle. Do not position next to any heat source e.g. cooker, boiler or in direct
sunlight etc.
Allow at least 10cm of space at the top and 10 cm of space on both sides of the appliance and between
the back of the appliance and the wall for adequate air circulation. The appliance is not designed for
recessed installation ("building in").
Install on a good firm level surface, and any unevenness of the floor should be corrected prior to
installation, slight unevenness can be overcome by adjusting the front feet.
NOTE: If the appliance is positioned on a carpet, soft floor covering you should readjust the front feet
once the appliance has had time to settle.
OPERATION
• This appliance is designed to operate in ambient temperature between 16℃and 38℃. If these
5. Crisper
6. Levelling foot
7. Egg tray
8. Bottle shelf
5