Connecting To The Control Panel - Smanos VD8000 Manual Del Usuario

EN
High sensitivity Medium Sensitivity

Connecting to the Control Panel

Please connect the detector with control panel before use:
1. Make sure the control panel is under pairing state (please refer to
the relative user manual).
2. Knock once on the surface of the detector to simulate an alarm (LED
flashes once), when a beep is heard from control panel, it means
the pairing is successful.
Installation
1. Remove the insulating strip; the detector will enter working state.
2. Clean the surface of object to be installed.
3. Fix the detector on the middle of the object's surface with double-
sided adhesive tape and make sure the antenna is upward.
Low sensitivity
Note:
strength on objects, but also the strength, frequency and duration of the signal.
Power Supply:
Static Current:
Alarm Current:
Transmitting Distance:
Radio Frequency:
Housing Material:
Operation Condition:
Temperature: 0°C ~ +55°C
Relative Humidity: < 80% (non-condensing)
Detector Dimensions (L x W x H):
Whether a vibration signal will be detected depends on not only the knocking
Specifications
DC 3 V (AAA 1.5 V LR03 x 2 PCS)
< 29 uA
< 22.2 mA
< 80 m (in open area)
868 MHz
ABS plastic
54 X 14.5 X 107 mm
EN