Hexa Therma CDT/2400 Manual De Usuario página 39

Betriebsanleitung | Manual de usuario | Operating instructions
1. Connection of the PT100 sensors to measure the temperature. It is possible to use two
sensors or only one. Two sensors are recommended when greater redundancy is desired.
Note the pin numbering and the connector numbering.
2. Grounding (PE) of the power supply and heating.
3. Connection of phase (L) and neutral (N) for power supply.
4. Connection of the phase (L) and the neutral (N) for the heater
Make sure that the grounding wires (PE) are properly connected.
Version 1.0 / 2020
HEXA THERMA
39
www.hexatherma.com
[email protected]