Internal Memory - Aigostar 8433325503093 Manual De Instrucciones

GB
Cancelling a programme
Occasionally you may also need to cancel
a program you have selected in error.
1. To cancel a program: Press and hold the
"START/CANCEL" button for 3 seconds.
2. The display reverts to the Default
Mode.
Keep Warm Setting
(Smooth, Chunky, Soymilk, Jam ONLY)
1. When a programme is completed the appliance enters a
keep warm mode. In this state the contents are kept warm for
1 hour after the program ends.
2. If a program is cancelled, the keep warm is automatically
cancelled.
Other Conditions
Liquid Level Too High:
If the liquid level exceeds the MAX level in the appliance the
water level sensor will operate and the unit will not switch on.
This condition is indicated by all the indicators flashing
simultaneously. Lift the machine head off, and reduce the liquid
level to the MAX mark. The unit will now operate normally.
System Errors:
1. If the buzzer sounds and all display lamps flicker, there may
be a system error. Unplug the machine and wait a few minutes
before reconnecting the unit. If the display lights still flicker
discontinue using the machine and contact the Tesco helpline.
2. The appliance has a safety thermostat which switches off the
power if the unit over heats. If this happens, remove any food
from the jug and allow the unit to cool for 30 minutes before
using it again.

Internal Memory:

If there is a power cut or if the power cord is accidentally pulled
out: If the power is restored within 3 minutes the internal
memory of the appliance will restore normal operation. If the
power is removed for longer than three minutes, the appliance
will reset itself. Any contents should now be discarded and the
machine must be cleaned before further use.
09
Cleaning
1. After use unplug the appliance and allow the appliance to
cool for a few seconds.
2. Pour out the soup into a suitable container.
3. Lift off the machine head, pour 1.5 litres of fresh water into
the appliance jug. Replace the machine head and plug the
appliance into the mains.
4. Select the blend programme and run the appliance for a
few seconds.
5. If you do this way soon after use this will help to loosen
any particles of food and minimize food particles drying on
to the appliance jug and the blending blade.
Cleaning the appliance
1. Unplug the appliance and remove the machine head.
2. The appliance jug can be cleaned with warm water and
sponge, rinsed with clean water and then dried with a clean
towel or kitchen paper.
3. Burned-on food will usually be at the base where the heating
element is. Half-fill the appliance jug with warm soapy water and
leave it for 15 minutes to soak. Remove any deposits with a
coarse sponge or plastic can sourer. DO NOT use a metal
scouring pad or other abrasive material to avoid scratching the
unit. Rinse and dry with clean towel or kitchen paper.
4.If there is some incrustation under the jug, it is a normal
phenomenon, just use vinegar to wipe it.
Machine Head
Run the lower section of the lid
incorporating the blending
blade under warm water, and
wipe with a clean damp cloth.
DO NOT touch the blade with
your hands.
WARNING:
DO NOT immerse the machine head or appliance jug in
water as they contain electrical components, Wipe them
with a barely damp cloth and dry carefully.
GB
10