Instalación Conforme A Ul; Field Wiring) Power Terminals; Short Circuit Current Rating; Branch Circuit Protection - Sew Eurodrive MOVIPRO PHE1 B Serie Instrucciones De Funcionamiento

Instalación eléctrica
6
Instalación conforme a UL
6.4 Instalación conforme a UL
6.4.1

(Field wiring) Power terminals

6.4.2

Short circuit current rating

6.4.3

Branch circuit protection

Model
PHE1.B-A15-...
PHE2.B-A15-...
6.4.4

Motor overload protection

6.4.5

Environmental rating

6.4.6

Wiring diagrams

42
Instrucciones de funcionamiento – MOVIPRO
NOTA
El siguiente capítulo se imprime siempre en idioma inglés, independientemente del
idioma de esta documentación, debido a los requerimientos UL.
Use 75 °C copper wire only.
Suitable for use on a circuit capable of delivering not more than 5000 rms symmetrical
amperes when protected by 25 A, 600 V non-semiconductor fuses or 500 V minimum
25 A maximum inverse time circuit breakers.
Max. voltage is limited to 500 V.
Integral solid state short circuit protection does not provide branch circuit protection.
Branch circuit protection must be provided in accordance with the National Electrical
Code and any additional local codes.
For maximum branch circuit protection see table below:
Non Semiconductor Fuses (currents are
maximum values)
25 A/600 V
The devices are provided with load and speed-sensitive overload protection and ther-
mal memory retention upon shutdown or power loss.
The trip current is adjusted to 140 % of the rated motor current. For further informa-
tion, refer to chapter "Technical data".
Type 1
For wiring diagrams, refer to chapter "Electrical installation".
®
PHE..B-A15-.1X0..B-00
SCCR: 5 kA/500 V
When protected by:
Inverse-Time Circuit Breaker (currents
are maximum values)
25 A/500 V