Installation Instructions; Window Requirements; Preparation Of Cabinet - Kenmore Elite 580.77087710 Manual De Uso Y Cuidado

Aire acondicionado inteligente para habitación
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Window Requirements

Size
NOTE: Secure all supporting parts to firm wood,
masonry, or metal.
• This room air conditioner is designed for installation in
standard double-hung windows with actual opening
widths from 22" to 36".
• The upper and lower window sash must open
sufficiently to allow a clear vertical opening of 13"
from the bottom of the upper sash to the inside sill.
• The height offset between the inside sill and outside sill
must be less than 1 ¼".
22" to 36"
13" min
Clearance
Proper clearance enhances the cooling efficiency of the
product.
If a storm window presents interference, fasten a 2"
1
wide wood strip to the inner window sill across the
full width of the sill. The wood strip should be thick
enough to raise the height of the window sill so that
the unit can be installed without interference by the
storm window frame.
(See drawing.) The top of the wood strip on the
2
inside sill should be approximately ¾" higher
than the storm window frame or wood strip on the
outside sill to help condensation to drain properly to
the outside.
If necessary, install a second wood strip (same
3
thickness as first strip) across the full width of the
outer sill, flush against the back of the inner sill. This
will raise the L bracket as shown.
Wood Strip Mounted
on Top of Inner Sill
Inner Sill
Wood Strip for
L Bracket
Indoors

INSTALLATION INSTRUCTIONS

¾"
L Bracket
Clearance
Storm
Window Frame
Outer Sill
Outdoors

Preparation of Cabinet

Insert the upper and bottom curtain panel rails into
1
the upper and bottom panel guides on each side of
the unit. Fasten the panels to the unit with 4 type A
screws on each side.
Upper Guide
Left Curtain Panel
Bottom Guide
Screws (Type A)
NOTE: Use a long screwdriver to make installing the
screws easier.
CAUTION
The bottom panel guides are easily broken. Be
careful with them when installing the cabinet.
Cut the adhesive-backed window sash seals (Foam-
2
PE) to the proper length. Peel off the backing and
attach the foam to the underside of the window
sash and the bottom of the window frame.
8
Right Curtain Panel
Foam-PE
(Adhesive backed)

Capítulos

Tabla de contenido
loading

Tabla de contenido