Mounting Instructions - MSA FlameGard 5 MSIR Guía De Inicio Rápida

FlameGard 5 MSIR
Quick Start Guide
4.

Mounting Instructions

5. Wall Mount Assembly
6. Testing the Detector Using Test Lamp
Test the integrity of your system by using a Test Lamp. The original configuration (i.e.
sensitivity and relay options) can be changed by referring to Section 3.5. of the manual
and then changing the dipswitch settings located on the bottom of the power board
(SW1).
The instrument is now ready to operate. Please consult the Test Lamp manual for more
information on the instrument's many features. If you have any problems in the set-up or
testing of the detector, please refer to the "Trouble Shooting Section", or call the factory
direct.
7. Applying Power to the Detector
Two light emitting diodes (LEDs) are visible through the window. Immediately upon
powering up the detector, both LEDs will start blinking alternately for 15 seconds. The
unit will then enter the "Ready" mode. During the "Ready" mode, the green LED will
flash off 0.5 seconds every 5 seconds.
GB
Flame Detector
MAN5MSIR-QG/01