Filling The Water Tank - Rowenta IS6300 Manual De Instrucciones

Notice ROWENTA IS6300-1800128731_110X154 19/12/12 11:12 Page6
DESCRIPTION
1. Steam head
2. Steam head hook
3. Built in hanger
4. Rotary trouser/dress clips
5. Hanger holder
6. Roll & press system: vertical support
shade
7. Roll & press system: rolling and
locking handle
8. Roll & press system: locking hook
9. Hanger fastening screw
10. Pole locking clips
11. Telescopic pole
12. Electric cord holder
BEFORE USE
1 • Garment steamer assembly
Pole assembly
1. Unscrew the pole's fastening screw on the base of the pole. (fig. 1)
2. Hold the pole such that the cord holder is on the left. Check that the 2 pole clips are
unlocked. (fig. 2)
3. Insert the pole into the base by pressing downwards until the holes of the pole and
base are at the same level, so that you can put the screw back. If the holes are not
aligned, check that the clips of the pole are well and truly unlocked. (fig. 3)
4. Screw the pole fastening screw back in as far as it will go so that the pole is firmly
fixed to the base. (fig. 4).
5. Adjust the pole to its maximum height by sliding it upwards (fig. 5) then locking the
2 clips. (fig. 6). Make sure the 3 segments of the pole are fully extended.
Hanger with Roll & Press system assembly
1. Unscrew the hanger fastening screw at the bottom of the hanger. (fig. 7)
2. Hold the hanger such that the Roll & Press system handle is on the same side as the
locking hook.
3. Insert vertically the hanger on the top of the pole. The holes at the bottom of the
hanger and in the pole should be at the same level. (fig. 8)
4. Put the screw back and screw in as far as it will go so that the hanger is firmly fixed
to the pole. (fig. 9)
5. Install the steam head between the hanger hooks.
2 • Filling the water tank
IMPORTANT: Never use water that contains additives (starch, perfume, aromatic subs-
tances, softener, etc) in the steamer. Additives such as these can affect the properties
of the steam and lead to the formation of deposits.
• Ensure that the steamer is unplugged. Remove the water tank from the base of the
appliance by pulling the handle upwards (fig. 10). Unscrew the tank cap and fill the
tank. (fig. 11). Maximum capacity is indicated by the "max" mark.
• The steamer must be used with TAP WATER. If the water in your area is hard, Rowenta
13. Electric cord
14. Velcro strip
15. Pole fastening screw
16. Steam hose connector
17. Removable water tank
18. ON/OFF pedal
19. Transport wheels
20. Textile steam hose
21. On/ off light
22. Built in accessories
a. Fabric brush
b. Lint pad
c. Delicates steam cap
6
•
•
U
1
•
•
•
•
•
2
T
•
•
•
•
•
•
•
•
•
•
•
•