Installation Procedures - HQ EL-PIR70 Manual Del Uso

This sensor is an active motion detector. The integrated HF sensor emits high-
frequency electro-magnetic wave (5.8GHz) and receives their echo. The sensor
detects the change in echo from even the slightest movement in the light's detection
zone. A microprocessor then triggers the "switch light ON" command. Detection is
possible through doors, panes of glass or thin walls.
Detection zones for ceiling mounting
1) Minimum reach 1m dia.
2) Maximum reach 8m dia.
Detection zones for wall mounting
3) Minimum reach 1m dia.
4) Maximum reach 8m dia.
Important: persons or objects moving towards
the light are detected best!

Installation procedures

1. Take down the top cover by turning it anti-clockwise (see fig.1), and then tighten off
the two screws fixing middle cover (see fig. 2);
2. Hold base against the wall and mark drill holes, paying attention to any existing
wiring in the wall;
3. Drill the holes, insert wall plugs (6mm dia);
4. Put the power wire and load wire through the base holes;
5. Screw the base into place (see fig. 3);
6. Connect the mains power supply and the load wire to the connection terminal
according to connection-wire mark.
7. Close the middle cover (see fig. 3) and adjust knob to setting;
8. Fit glass shade and turn it clockwise (see fig. 3).
fig 1 fig 2
1
fig 3