Velleman TRC1 Manual De Instrucciones

TRC1 – REMOTE CONTROLLED HELICOPTER
1. Introduction & Features
Thank you for buying the TRC1! Please read the manual thoroughly before bringing this device into service.
If the device was damaged in transit, don't use it and contact your dealer.
Your TRC1 is easy to pilot thanks to its proportional control, and has a maximum flight altitude of more than 15 meters!
Learning to fly a radio-controlled helicopter is a lot of fun, and these basic instructions will help you to get started.
2. Contents
The complete TRC1 set consists of: 1 helicopter, 1 remote control, 1 helipad charging station and 1 manual.
1. tail rotor
2. antenna
3. charging port
4. on/off switch
5. landing gear
6. main rotor
3. Batteries
a. Batteries
• Always install batteries with the polarity as indicated on the device itself.
• Do not mix new and old batteries.
• Do not mix different sizes and types of batteries (alkaline, rechargeable...)
• Do not attempt to recharge non-rechargeable batteries
• Only use batteries of the recommended type and rating or equivalent.
• We recommend connecting the charging port with a voltage adapter (e.g. PS1208, not incl.) via the DC input.
b. Remote Control
Required: 6 AA batteries
1. Use an appropriate screwdriver to unscrew the battery compartment screw at the bottom of the remote control.
2. Take off the battery compartment lid.
3. Install the 6 AA batteries. Make sure the polarity is correct.
4. Put the battery compartment lid back and fasten the screw.
TRC1
7. antenna
8. green power LED
9. red speed control LEDs
10. on/off switch
11. trigger
12. launching Rods
13. green/red charging LED
14. charging button
15. on/off switch
16. DC input
17. charge nozzle
- 1 - VELLEMAN