Tabla de contenido
Idiomas disponibles
Idiomas disponibles
EN
Wear eye protection to protect
your eyes.
Wear ear protection to protect
your ears.
Warning: Do keep away from fire.
Warning: Do keep away from the
hot parts.
SPECIFIC RULES FOR
BLOWER/VACUUMS
Do not use the machine to pick up
humid material, water, liquids, pieces
of glass, iron, stones or tin cans, this
could be very dangerous for you and
the machine.
Do not use the machine to pick up hot
embers or material which is burning,
smoking or smoldering.
Do not use the machine to pick up lit
cigarettes.
Do not use the machine to pick up
material which has been
contaminated by flammable or
explosive materials. Do not suck in
highly flammable fumes.
Always check that the material picked
up by your machine is not flammable,
toxic or explosive.
Do not use the vacuum mode without
the dust bag in place.
Always keep the area to be cleaned
free from wires, stones, debris, tin
cans and other obstacles.
Avoid colliding with hard objects
which could damage your machine.
Keep bystanders and animals at least
15m away from the working area.
Do not manually insert objects into the
blower/vacuum tube.
Do not insert your hands and fingers
into the vacuum opening or exhaust
opening.
Hold the machine firmly in both hands
when working with it.
The machine must not be used by
anyone under the age of 16.
NOTE: Place the unit on the
ground or on a work bench to
make attachment installation or
removal easier.
ASSEMBLING THE BLOWER
Push the protection into the straight
nozzle pipe, and then push the blower
nozzle pipe over the straight nozzle
pipe and locking pin, The arrowhead
on the blower nozzle pipe should be
on the same line with the straight
nozzle pipe. Rotate the pipe clockwise
to lock. Then tighten the screw in
place to secure. (Fig. 1).
With the air vent closed, push the
straight
nozzle
pipe
discharge port and locking pin, the
arrowhead on the straight nozzle pipe
should be on the same line with the
volute case. Rotate the pipe clockwise
to lock.(Fig. 2).
Tighten the screw in place to secure.
(Fig. 3).
ASSEMBLING THE VACUUM
Loosen the Cage Screw and pull
down the Cage (Fig. 4).
Install vacuum tubes in sequence
shown, aligning the grooves on the
nozzles with the pegs. Slide the nozzles
clockwise onto the pegs(Fig. 5).
Rotate the connector pipe clockwise
to lock, the arrowhead on the
over
the
connector pipe should be on the same
line with the volute case. (Fig. 6).
Tighten
secure(Fig. 7)
Insert the connector pipe into the side
opening of the vacuum bag. Wrap the
Velcro strap around the bag and pipe
to secure the bag in place. Place the
shoulder strap over your left shoulder
and
adjust
Adjustment as necessary. (Fig. 8).
the
screw
in
place
the
Shoulder
Strap
to
Tabla de contenido
