ARTROMOT SP3 Instrucciones De Uso página 66

n Dorsal extension / plantar flexion
therapy documentation
ARTROMOT®-SP3 Comfort devices with
patient chip card have a special docu-
mentation function which provides a log
of all therapy sessions.
The device run times as well as the range
of motion of the sessions are recorded.
The collected data are presented graphi-
cally in the form of two curves in a coor-
dinate system (X-axis = range of motion
/ Y-axis = time) where the upper curve
illustrates the trend of the dorsal exten-
sion movement and the lower curve the
trend of the plantar flexion movement.
n Inversion / eversion therapy
documentation
ARTROMOT®-SP3 Comfort devices with
chip card have a special documenta-
tion function which provides a log of all
therapy sessions.
The device run times as well as the range
of motion of the sessions are recorded.
The collected data are presented graphi-
cally in the form of a coordinate system
(X-axis = range of motion / Y-axis = time)
where the upper curve illustrates the
trend of the eversion movement and the
lower curve the trend of the inversion
movement.
LEVEL 5:
n Stretching in dorsal extension
With the special "stretching in dorsal
extension" function the carriage gently
stretches the joint by bending the foot
upward.
Starting at the middle position the car-
riage will first move to the programmed
plantar flexion value and then to the
programmed dorsal extension value.
Subsequently the carriage reverses 5°
towards plantar flexion and then moves
very slowly back again to the pro-
grammed dorsal extension value (display
). After that it attempts to attain an-
other 5°, moving even slower than before
(display ).
If a high resistance toward the additional
5° is sensed, the reverse on load function
is automatically activated and the car-
riage moves in the opposite direction.
This stretch cycle is repeated ten times.
After that the carriage moves to the pro-
grammed maximum plantar flexion value
and restarts the cycle "stretching in dorsal
extension".
Default setting: disabled
Note!
– If a pause has been programmed, the
carriage will stop for the pause each
time the maximum stretching value is
attained.
– Enabling the stretching in dorsal
extension function automatically
disables motor B. The only move-
ment performed is dorsal extension /
plantar flexion.
– It is not possible to combine a second
stretching function with the special
"stretching in dorsal extension"
function.
– During operation, the display will
show the symbol
left-hand corner.
n Stretching in plantar flexion
With the special "stretching in plantar
flexion" function the carriage gently
stretches the joint by bending the foot
downward.
Starting at the middle position the car-
riage will first move to the programmed
dorsal extension value and then to the
programmed plantar flexion value.
Subsequently the carriage reverses 5°
towards dorsal extension and then moves
very slowly back again to the program-
med plantar flexion value (display
After that it attempts to attain another
5°, moving even slower than before
(display ).
If a high resistance toward the additional
5° is sensed, the reverse on load function
is automatically activated and the car-
riage moves in the opposite direction.
This stretch cycle is repeated ten times.
After that the carriage moves to the
programmed maximum dorsal extension
value and restarts the cycle "stretching in
plantar flexion".
Default setting: disabled
62
in the upper,
).