Rockford Fosgate M2 Serie Instrucciones De Instalación página 10

Installation
Mounting (M2-TS ONLY)
Flush Mount Option
1. Determine where the tweeter will be mounted. Ensure
an area large enough for the tweeter to mount evenly. Be
sure that the mounting location is deep enough for the
tweeter to fit; if mounting in a door, operate all functions
(windows, locks, etc.) through their entire operating
range to ensure there is no obstruction.
2. Mark the location for the mounting hole. Drill the hole
with a standard 1.75 inch (45mm) hole saw.
3. With a single center screw secure the inner cup from the
front of the door panel to the outer cup from back of the
door panel. Tighten the screw until balanced pressure is
applied to both faces of the mounting surface.
4. Feed the speaker wires through the cutout. Be sure to
observe proper polarity when connecting the wires. The
speaker's lead wires are indicated with a WHITE wire "+"
and a BLACK wire "-".
5. Simply snap the tweeter into place and secure with
a snap-on trim ring. Removal is easy if needed. The
protective grille on the tweeter is non-removable and an
integral part of the design.
Optional Horn Loading Mounting
1. Determine where the tweeter will be mounted. Ensure
an area large enough for the speaker to mount evenly. Be
sure that the mounting location is deep enough for the
speaker to fit; if mounting in a door, operate all functions
(windows, locks, etc.) through their entire operating
range to ensure there is no obstruction.
2. Mark the location for the mounting hole.
3. Cut or use a hole saw to drill a 3-5/8" (91mm) hole for the
flange to fit.
4. Once you have the hole cut, insert the flange and mark
the locations for the mounting screws. Predrill your
mounting screw holes.
5. Assemble the horn flange, o-ring, tweeter and retaining
ring together. Pay close attention to the alignment tab on
both the tweeter and flange. These need to be lined up
for proper tweeter orientation in the flange.
6. Feed the speaker wires through the cutout. Be sure to
observe proper polarity when connecting the wires. The
speaker's lead wires are indicated with a WHITE wire "+"
and a BLACK wire "-".
7. Secure the flange with the included stainless steel
mounting hardware.
10
Flush Mount Clamp
Flush Mount Clamp
Optional Horn Loading Mounting Flange
Optional Horn Loading Mounting Flange
Use tip of small flat screwdriver to
remove tweeter
Panel
Use tip of small flat screwdriver to
remove tweeter
Panel
Tweeter
O-ring
Flange
Retainer
Tweeter
O-ring
Flange
Retainer