Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Setting up your LCD TV
Keep the remote control away from heat sources or humid areas.
Strong light may affect the signal between the remote control and the
remote sensor on your LCD TV. If the remote control does not work,
change the position of the remote control.
Make sure that the batteries are alkaline batteries. Batteries must be of
the same type.
Do not mix old and new batteries.
Do not use rechargeable batteries.
Connecting an antenna
Caution: Do not bend the bronze wires on the cables.
To connect an antenna:
1 Make sure that your LCD TV is turned off.
2 Plug one end of a 75 ohm cable (not included) into the ANT IN
jack on the back of your LCD TV.
3 Plug the other end of the cable into the outside antenna jack.
Notes: To improve picture quality in an area with poor signal reception,
install a signal amplifier.
If you want to connect two TVs to the antenna, install a two-way signal
splitter.
Connecting cable or satellite TV
To watch cable or satellite TV, you need a TV tuner device or a cable or
satellite TV converter box.
There are two ways to connect cable or satellite TV to your LCD TV.
Option 1: To connect cable or satellite TV:
1 Make sure that your LCD TV and converter box are turned off.
2 Connect a 75 ohm cable (not included) to the RF jack on the cable
or satellite TV converter box and to the ANT IN jack on the back of
your TV.
Caution: Do not bend the bronze wires on the cables.
3 Connect one end of a 75 ohm cable (not included) to the cable jack
on the cable or satellite TV converter box and to the cable or
satellite TV wall jack.
4 Set the channel switch on the cable or satellite TV converter box to
3 or 4.
5 Turn on your LCD TV and the converter box, then tune your LCD TV
to the same channel you set the channel switch to.
6 Use the cable or satellite TV remote control to tune channels.
Option 2: To connect cable or satellite TV:
1 Make sure that your LCD TV and cable or satellite converter box are
turned off.
2 Connect audio and video out jacks on the cable or satellite TV
converter box to the AUDIO IN and VIDEO IN jacks on the back of
your TV.
3 Turn on your LCD TV and the converter box, then press INPUT to
select TV.
4 Use the cable or satellite TV remote control to tune channels.
Connecting a component video device
To connect a component video device:
1 Make sure that your LCD TV and component video device are
turned off.
2 Connect the component video device's video output jacks (Y, Pb,
Pr) to the COMPONENT IN (Y, Pb, and Pr) jacks on the back of your
LCD TV.
3 Connect the component video device's audio output jacks to the
AUDIO IN (L and R) jacks on the back of your TV.
4 Turn on your LCD TV and the component video device, then press
INPUT to select Component.
Connecting an S-Video device
To connect an S-Video device:
1 Make sure that your LCD TV and S-Video device are turned off.
2 Connect an S-Video cable (not included) to the S-Video out jack on
the S-Video device and to the S-VIDEO jack on the back of your
LCD TV.
5
Capítulos
Tabla de contenido
