Tabla de contenido
Idiomas disponibles
Idiomas disponibles
PERSONALISATION of the body fat analysis results display (BFA)
In the factory setup, the following data is displayed: body fat, body water mass, bone mass and muscular mass.
You may choose to remove particular data from the display.
• Press and hold key [MODE] for more than 10 seconds to go into the setup mode.
• Go from the PRINT function and ID NO setup by pressing [
• The screen then displays «BFA». For each data, use keys [▲] or [▼] to select ON or OFF and thus deactivate
or activate its display. Confirm your selection by pressing key [
PRINT FORMAT FROM THE BMI BALANCE
ID
Age:
Gender:
Activity
Height
Weight
BMI
SPECIAL INDICATIONS
Err0
Initial zero error. Get off the scales, wait
for the display to show 0.0 and restart
the measurement.
Err1
Unstable weight: restart the weighing.
Err2
Overload: remove the weight
immediately.
Err3
Body impedance beyond the limit
(100 ohm to 1kohm): restart the
measurement.
If Err3 appears often and depending on
your skin type (thin or thick), it may be
necessary to moisten your feet to ensure
better contact with the electrodes.
Err4
Body fat percentage out of range 4-50%:
restart the measurement.
Err5
Water volume out of range.
Moisten your feet and restart.
bAtt
Replace the battery.
30
ELECTRONIC MEDICAL SCALE CLASSE III
MEASUREMENT RESULTS
0001
30 yrs
Female
Normal
175,0 cm Bone mass
68,0 kg
21,5
EN
/ Tare Height].
/ Tare Height].
Body fat
Body fat
Fat-free mass
Body water mass
Muscle mass
AdErr
Hardware problem. Contact your retailer.
EEP
Hardware problem. Contact your retailer.
Ustb
Unstable zero. Wait for the display to
show 0.0 and restart the measurement
10 %
5,0 kg
60,0 kg
50 %
4,5 kg
20,5 kg
Tabla de contenido
