Camo DRIVE Manual Del Propietário página 8

UNLOADING SCREW STRIPS
To unload the installed strip of
screws, slide the picker up to the
nose of tool where strip was first
attached. This will release the
tension and the strip should pop
free of the picker teeth.
ATTACHING YOUR DRIVER DRILL
CAMO DRIVE is able to be used with either a tightening chuck or a locking chuck.
® ™
TO ATTACH CAMO DRIVE
® ™
To attach to a tightening chuck,
simply insert the large collar of
the drive shaft into the drill chuck
and tighten
TO ATTACH CAMO DRIVE
® ™
Take an extra CAMO
®
bit and insert into the end of the
collar
Make sure the drive shaft is securely tightened before driving screws
Slowly return the picker to the
bottom of tool. Caution! Be very
careful not to let go of the picker
as it will recoil very quickly and
could damage the tool when it
strikes the stop.
TO A TIGHTENING CHUCK
TO A LOCKING CHUCK
DRIVE Attach your driver drill's locking
™
chuck to the smaller bit
8